Each public restroom must have at least one wheelchair accessible stall. ADA bathroom requirements state that this type of stall shall be at least 56 inches deep for wall-hung toilets and at least 59 inches deep for floor-mounted toilets. The width must be at least 60 inches, as measured from the right angle of the sidewall or partition. You'll need two grab bars in your ADA compliant bathrooms. In wheelchair-accessible stalls, there will be one grab bar on the side closest to the toilet and another on the back wall. In ambulatory accessible stalls, there will be two grab bars on either side wall. A side wall grab bar should be at least 42 inches long. The text of the Americans with Disabilities Act of 1990 (ADA), including changes made by the ADA Amendments Act of 2008. the ADA was later reformatted and published in volume 42 (called "title 42") of the United States Code. One small part of the ADA is found in title 47 of the United States Code. The text below mirrors the law as it is The full text of the 2010 Standards is available for review at www.ada.gov. In the Department´s revised ADA title II regulation, 28 CFR 35.104 Definitions, the Department defines the term "2010 Standards" to mean the 2010 ADA Standards for Accessible Design. This guide explains requirements in the ADA Standards for bathing rooms. Required Compliance [ §213] Plumbing and building codes address the number and type of bathing rooms and fixtures required for a facility. The ADA Standards, on the other hand, address access to bathing rooms where they are provided. 1. At fixtures not required to comply with Section 1103.11.2, reinforcement in accordance with Section 1104.11.1 shall be permitted.. 2. Reinforcement is not required in a room containing only a lavatory and a water closet, provided the room does not contain the only lavatory or water closet on the accessible level of the dwelling unit. .

ada codes for bathrooms